Injection guide · EMD Serono, Inc.

How to inject OVIDREL

This guide takes you through injecting OVIDREL from its PreFilled Syringe, one step at a time. It covers 4 stages, from getting ready to cleaning up.

What the guide covers

  1. 1Getting ready3 steps
    1. One syringe, one injection

      Ovidrel® PreFilled Syringe is intended for a single subcutaneous injection. Any unused material should be discarded.

    2. Wash your hands

      Step 1: Wash your hands thoroughly with soap and water.

    3. Get comfortable and clean the site

      Make yourself comfortable by sitting or lying down. Carefully clean the injection site on the stomach with an alcohol wipe and allow it to air-dry.

  2. 2Inject2 steps
    1. Remove the needle cap

      Carefully remove the needle cap from the syringe. Do not touch the needle or allow the needle to touch any surface.

    2. Give the injection

      Inject the prescribed dose as directed by your doctor, nurse or pharmacist.

  3. 3Right after2 steps
    1. Gently withdraw the needle

      Step 4: Gently withdraw the needle.

    2. Gauze over the site

      Only if it applies.

      Discard the needle and syringe into your safety container. Place gauze over the injection site. If any bleeding occurs, apply gentle pressure. If bleeding does not stop within a few minutes, place a clean piece of gauze over the injection site and cover it with an adhesive bandage.

  4. 4Tidying up1 step
    1. Storage and clean up

      Remember that your injection materials must be kept sterile and cannot be reused.