Injection guide · Sandoz Inc.

How to inject leuprolide acetate (14-day kit)

This guide takes you through drawing up and injecting leuprolide acetate from the 14-day kit's multiple-dose vial, one step at a time. It covers 5 stages, from gathering your supplies to disposing of the needle and syringe.

What the guide covers

  1. 1Getting ready3 steps
    1. Gather your supplies

      Supplies you will need for the Leuprolide Injection: 1 vial of Leuprolide Injection a sterile 1 ml syringe (See Figure A) 1 cotton gauze 2 alcohol swabs 1 puncture resistant sharps container (See “Disposal of used syringes, needles, and vials”)

      Do not share your syringes with other people, even if the needle has been changed. You may give other people a serious infection or get a serious infection from them.

    2. Wash your hands

      Wash hands thoroughly (See Figure B) and dry them with a clean towel.

    3. Check the liquid and clean the vial top

      Check the liquid in the vial. It should look clear. Do not use if it is not clear or if it has particles in it. If using a new vial, flip off the plastic cover to expose the grey rubber stopper. Use an alcohol swab to cleanse the metal ring and rubber stopper on the medication vial every day, just before you use it (See Figure C).

  2. 2Drawing up6 steps
    1. Unwrap a syringe

      Remove outer wrapping from one syringe (See Figure D).

    2. Pull the plunger to your dose mark

      Pull the syringe plunger back until its tip is at the proper mark for the prescribed dose (See Figure E).

    3. Uncover the needle

      Uncover needle by pulling the cap straight off (See Figure F). Do not touch the needle.

    4. Push air into the vial

      Place the vial on a clean, flat surface. Inject the needle through the center of the rubber stopper on the vial. Push the plunger all the way in to inject air into the vial (See Figure G).

    5. Turn the vial upside down

      Keep the needle in the vial. Lift the vial and turn it straight upside down. Check to see that the needle tip is in the liquid (See Figure H).

    6. Draw up your dose

      With the needle tip in the liquid, slowly pull back the plunger until syringe fills to the proper mark (See Figure I). If any bubbles appear in the syringe, remove them by pushing the plunger up slowly. With the needle tip still in the liquid, pull the plunger until it is once more at the proper mark.

  3. 3Inject3 steps
    1. Choose and clean the injection site

      Choose a different injection site each day. Clean the injection site with a new alcohol swab.

    2. Pinch the skin and insert the needle

      Hold the skin fold between your thumb and your index finger or as you were instructed by your doctor. Inject the needle straight into the skin quickly, as shown by your doctor in a 90° angle (See Figure J).

    3. Inject the medicine

      Push the plunger to inject the medicine.

  4. 4Right after1 step
    1. Remove the needle and wipe the skin

      Remove the needle at the same angle it was inserted (90°) (See Figure K). Wipe the skin with a cotton gauze.

  5. 5Tidying up1 step
    1. Dispose of the needle, syringe and vial

      Put the used needles, syringes, and vials in a FDA-cleared sharps disposal container right away after use (See Figure L). Do not throw away (dispose of) loose needles, syringes, or vials in your household trash.