Injection guide · Ferring Pharmaceuticals Inc.

How to inject FYREMADEL

This guide takes you through injecting FYREMADEL from its prefilled syringe, one step at a time. It covers 5 stages, from getting ready to disposing of the syringe.

What the guide covers

  1. 1Getting ready2 steps
    1. One syringe, one dose

      Ganirelix acetate injection is supplied in a single-dose, sterile, prefilled syringe and is intended for SUBCUTANEOUS administration only.

    2. Wash your hands

      Wash hands thoroughly with soap and water.

  2. 2Ready to inject3 steps
    1. Choose the injection site

      The most convenient sites for SUBCUTANEOUS injection are in the abdomen around the navel or upper thigh.

    2. Clean the site and let it dry

      The injection site should be swabbed with a disinfectant to remove any surface bacteria. Clean about two inches around the point where the needle will be inserted and let the disinfectant dry for at least one minute before proceeding.

    3. Remove the needle cover

      With syringe held upward, remove needle cover.

  3. 3Inject3 steps
    1. Pinch up the skin

      Pinch up a large area of skin between the finger and thumb. Vary the injection site a little with each injection.

    2. Insert the needle

      The needle should be inserted at the base of the pinched-up skin at an angle of 45 to 90° to the skin surface.

    3. Press the plunger slowly

      Once the needle is correctly placed, depress the plunger slowly and steadily, so the solution is correctly injected and the skin is not damaged.

  4. 4Right after1 step
    1. Withdraw and apply pressure

      Pull the syringe out quickly and apply pressure to the site with a swab containing disinfectant.

  5. 5Tidying up1 step
    1. Dispose of the syringe

      Use the sterile, prefilled syringe only once. Discard the unused portion and dispose of it properly.