Injection guide · EMD Serono, Inc.

How to mix and inject CETROTIDE

This guide takes you through mixing and injecting CETROTIDE from its vial and pre-filled diluent syringe, one step at a time. It covers 6 stages, from washing your hands to disposing of your needle.

What the guide covers

  1. 1Getting ready3 steps
    1. Wash your hands

      Wash your hands thoroughly with soap and water.

    2. Lay out your supplies

      On a clean flat surface, lay out everything you need (one vial of powder, one pre-filled syringe, one injection needle with a yellow mark, and one injection needle with a grey mark).

    3. Uncap and clean the vial

      Flip off the plastic cover of the vial. Wipe the aluminum ring and the rubber stopper with an alcohol swab.

  2. 2Mixing4 steps
    1. Attach the yellow-marked needle

      Take the injection needle with the yellow mark and remove the wrapping. Take the pre-filled syringe and remove the cover. Twist the needle on the syringe and remove the cover of the needle.

    2. Add the water to the vial

      Push the needle through the center of the rubber stopper of the vial. Inject the water into the vial by slowly pushing down on the plunger of the syringe.

    3. Swirl gently to mix

      Leave the syringe in the vial. While carefully holding the syringe and vial, swirl gently to mix the powder and water together. When it is mixed, it will look clear and have no particles in it. Do not shake or you will create bubbles in your medicine.

    4. Draw up all of the medicine

      Draw the total contents of the vial into the syringe. If liquid is left in the vial, invert the vial, pull back the needle until the opening of the needle is just inside the stopper. If you look from the side through the gap in the stopper, you can control the movement of the needle and the liquid. It is important to withdraw the entire contents of the vial.

  3. 3Ready to inject3 steps
    1. Change to the grey-marked needle

      Detach the syringe from the needle and lay down the syringe. Take the injection needle with the grey mark and remove its wrapping. Twist the needle on the syringe and remove the cover of the needle.

    2. Push out the air bubbles

      Invert the syringe and push the plunger until all air bubbles have been pushed out. Do not touch the needle or allow the needle to touch any surface.

    3. Choose and clean the injection site

      Choose an injection site in the lower abdominal area, preferably around, but at least one inch away from the belly button. Choose a different injection site each day to minimize local irritation. Take a second alcohol swab and clean the skin at the injection site and allow alcohol to dry.

  4. 4Inject1 step
    1. Give the injection

      Inject the prescribed dose as directed by your doctor, nurse or pharmacist.

  5. 5Right after1 step
    1. What you may notice at the site

      Mild and short lasting reactions may occur at the injection site like reddening, itching, and swelling. Nausea and headache have also been reported.

  6. 6Tidying up2 steps
    1. Dispose of the syringe and needles

      Use the syringe and needles only once. Dispose of the syringe and needles immediately after use (put the covers on the needles to avoid injury).

    2. Into the sharps container

      A medical waste container should be used for disposal.